Heater Switch& A/c Bulb

[tin2.3]

hi all,

can anyone help please.

1, i have only heater fan switch that works on setting 4, is it the switch or somthing eles?.

 

2, how do you change the a/c blulb?.

many thanks tin2.3

[Audiman]

1) Fan working only setting 4 = failure of Resistor Pack.

You're switch is more than likely okay.

 

The Resistor pack cost about

[mk2vr6]

the ac wont work untill you get the resistor pack replaced

[Audiman]

Here some instructions and pictures I took a while ago to remove the Resistor pack.

 

1) Unclip the side plastic shown below:

 

 

2) Unclip the top flap on the glovebox

 

 

3) Unclip the the glovebox lever on the right-hand side. This is used to give the golvebox a soft opening/closing. Then unclip the golvebox from the bottom hinges and should be able to see th Resistor Pack in green.

 

 

4) Unclip the leads going into the Resistor pack

 

 

5) Unscrew the torx screw holding the Resistor pack

 

 

6) This is the Resistor pack

 

 

Re-installing the Resistor pack is the reverse procedure. Anyway hope this helps you.

[tin2.3]

hi all,

can anyone help please.

1, i have only heater fan switch that works on setting 4, is it the switch or somthing eles?.

 

2, how do you change the a/c blulb?.....sorry the bulb behind the control panel (air distribution switch)

many thanks tin2.3

thanks audiman will use your pictures and have a go

Edited September 8, 2008 by tin2.3